| ＊For
Your Safety.
|
|
 |
|
 |
|
| 1.Read safety instructions before operating
any pneumatic tools. Inspect the tool carefully and make sure you are completely familiar with all controlling aspects of the tool. 2.Wear safety glasses and hearing protection. 3.Dust mask and gloves are recommended. 4.Wear suitable clothes and safety shoes. Keep loose clothing, neckties, long hair and jewelry away from the tool. ・Before each use of the tool, check the air hoses and the connections from damage. ・Disconnect the tool from the air supply when replacing any accessories and changing tools. ・Secure the work piece with suitable clamping or holding devices. ・Keep other person away from the working area. ・Allow repairs to be performed only by a qualified technician. ・Vibration, repetitive motions or uncomfortable positions may be harmful to your body. |
|
 |
|
| ＊Air Supply & General Notes. | |
Readtheoperatinginstructionsofthepneumatictool.
・Before use, place a few drops of oil in the air inlet of the pneumatic tool. ・When under load, the pneumatic tool (1) requires an air pressure of approx. 6.3bar(630kPa). ・Clean the air filter(4) from time to time. ・Pressure that is too low reduces the performance of the pneumatic tool; pressure that is too high causes excessive wear. ・To prevent rust and reduce wear, clean and oil the pneumatic tool (1) after use. ・Store the pneumatic tool in a clean and dry place. ・Ensure that the pressurised air is clean and dry. ・Drain condensation at the air filter (4) and the compressor (8) daily. ・Use only original accessories and tools. |
|
 |
|
| ＊Conversion Factors. | |
| Length......1inch=25.40mm,1mm=0.04inch Weight......1kg=2.2lb,1lb=0.453kg Torgue......1Nm=0.74ft/lbs,1ft/lbs=1.35Nm |
|
 |
|
| |